Posts

Showing posts with the label i2c

Embedded Communication Protocol and Motor Control

Image
i2c I2C specifications defined maximum clock frequency of 100 kHz. This was later increased to 400 kHz as  Fast mode . There is also a High speed mode which can go up to 3.4 MHz and there is also a 5 MHz ultra-fast mode. I2C Interface I2C uses only two wires: SCL (serial clock) and SDA (serial data).  I2C Addresses Basic  I2C communication  is using transfers of 8 bits or bytes. Each I2C slave device has a  7-bit address  that needs to be unique on the bus. 7-bit address represents bits 7 to 1 while bit 0 is used to signal reading from or writing to the device. If bit 0 (in the address byte) is set to 1 then the master device will read from the slave I2C device. I2C Protocol In normal state both lines (SCL and SDA) are high.    Both need to be pulled up with a resistor to +Vdd. With I2C, data is transferred in  messages.  Messages are broken up into  frames  of data. Each message has an address fr...